Re: [cups] Printer on usb/parallel
Axel Braun <[email protected]>
| Newsgroups | gmane.comp.printing.cups.general |
|---|---|
| Message-ID | <1956655.KuSob2Lc0g@x1e> |
Am Dienstag, 6. Oktober 2020, 12:26:23 CEST schrieb Raphaël POITEVIN: > I'm trying to run an old printer, actually a Braille embosser, a basic-d > V4 which have only parallel port. I connected it behind an USB parallel > converter which is detected: /dev/usb/lp0. > > In cups interface localhost:631 I don't find any way to choose the > converter when adding a printer. You should be able to add/edit the DeviceURL manually, like: DeviceURI lpd://192.168.1.103/binary_p1 In your case it is probably usb:/dev/usb/lp0 (/etc/cups/printers.conf) HTH Axel _______________________________________________ cups mailing list [email protected] https://lists.cups.org/mailman/listinfo/cups