Re: [cups] Waiting for the printer to become available (forever)
Jörg Thümmler <[email protected]>
| Newsgroups | gmane.comp.printing.cups.general |
|---|---|
| Message-ID | <[email protected]> |
Am 03.02.21 um 01:07 schrieb Néstor: >> you have installed brothers sw from >> >> https://support.brother.com/g/b/downloadend.aspx?c=eu_ot&lang=en&prod=hll2350dw_us_eu_as&os=128&dlid=dlf006893_000&flang=4&type3=625&dlang=true >> ?? > > Yes! > >> there will kernel modules i assume, you can try to load manually, but >> restart seems easier to me... after that use lsmod to look, whether the >> brother module is loaded... something with brother or br2 might be > > ' lsmod | grep br ' gives no result, nor does ' modprobe -c | grep bro > ', `modprobe -c | grep br2`. > > So I guess that the module for brother printer is not installed. > >> next i wood browse to localhost:631 and have a look on the printers >> entry here ... or add it, if's not here. > > http://192.168.1.160:631/printers/HLL2350DW > > This is the printer's URL, configured with Brother's official driver. > > I have used the printer on a Raspberry pi 2, it was Ok but a bit slow, > now I have upgraded to a raspberry pi 4 4GiB RAM, exactly the same > system (I moved the microSD card into the new rpi4), reinstalled the > driver and no luck. > > Any ideas? > Hi, you have the pi2 left? I would put the card back and check the drivers by lsmod. There should be some brother thing, best, lsmod to a file and then check against the pi4's lsmod... -- cu jth _______________________________________________ cups mailing list [email protected] https://lists.cups.org/mailman/listinfo/cups