[cups] SSL in cups 2.3.3op2

I guess I forgot to put a subject on this so I am resending

Upgraded to Bullseye on Raspberry Pi 3B+  fromStretch. Far too many issues
with CUPS 2.3.3op2.


I need to get SSL activated so that Android 9 and up can print


I have found several pages on the internet with the same topic , some say
you only need to add the certificates and add some lines to cupsd.conf that
point to them but that apparently does not work . One page said they are
automatically generated.


Too many changes in CUPs and not enough  complete documentation . This is
what gives linux a bad name. We need full and complete documentation for
each specific version of CUPS

I also need to know if SAMBA driver support has been removed.

Thanks

Mark
_______________________________________________
cups mailing list
[email protected]
https://lists.cups.org/mailman/listinfo/cups