Re: showing commands sent from GSView to Ghostscript

"Russell Lang" <[email protected]> Mon, 15 Mar 2004 19:46:03 +1100

Newsgroups	gmane.comp.printing.ghostscript.gsview,gmane.comp.printing.ghostscript.windows
Message-ID	<405607FB.16823.FCDEAF1@localhost>

Gyro,

> I am performing some conversions from postscript to png using 
> GSView (v4.16). I presume that this program uses Ghostscript 
> (v8.14) for the actual conversions. Is there a way to see what 
> 'command line' is sent to Ghostscript for the conversions? I would 
> like to eventually use a batch script to do the conversion, so it 
> would be nice to have this information. These commands don't show 
> up in 'Show Messages'.

Start GSview with "gsview -d".  It will then dump more details into 
the "Show Messages" log.  GSview does a lot with PostScript commands, 
rather than the command line.


Russell Lang                   [email protected]
Ghostgum Software Pty Ltd      http://www.ghostgum.com.au/