Re: tool located in site_scons\site_tools\toolname causes ImportError
"Arndt Pauschardt" <[email protected]>
| Newsgroups | gmane.comp.programming.tools.scons.user |
|---|---|
| Message-ID | <[email protected]> |
I just checked, the place I was refering to is in chapter 1.1 of v3.0.1's UM. In 3.0.4 it's been corrected as you say ... so, yes, I should have read 3.0.4 before posting. Maybe it is a good idea if I start diff'ing the .txt versions of the doc to get the deltas before posting ... -----Ursprüngliche Nachricht----- Von: Mats Wichmann <[email protected]> Gesendet: Montag, 4. Februar 2019 15:49 An: SCons users mailing list <[email protected]>; Arndt Pauschardt <[email protected]> Betreff: Re: [Scons-users] tool located in site_scons\site_tools\toolname causes ImportError On 2/4/19 1:41 AM, Arndt Pauschardt wrote: > I'm aware of the fact that the SCons manual says that Py3 is not > supported yet, but following this mailing list seems to indicate that > using Py3 is no longer a high risk thing. Been gradually stamping out places where it says this, Py3 supported for quite a while now. Was there someplace particular that still claims Py3 is not supported? _______________________________________________ Scons-users mailing list [email protected] https://pairlist4.pair.net/mailman/listinfo/scons-users