Re: func in command doesn't get exuecuted.

me puts the dumbass hat and goes to stand in the corner.

I cannot belive how much I wasted because this small error.

Thanks Bill.

you saved me from doing an open heart surgery to my project''

Dagg

Sent: Thursday, September 09, 2021 at 9:15 PM

From: "Bill Deegan" <[email protected]>

To: "SCons users mailing list" <[email protected]>

Subject: Re: [Scons-users] func in command doesn't get exuecuted.

Dagg,

You're running "scons -n" (with other args) right?

Then of course no builders are actually run.

-Bill

On Thu, Sep 9, 2021 at 7:10 AM daggs <[email protected] > wrote:

Greetings,

I have a target I want to rebuild everytime I run scons.

so I defined the following command:

env.AlwaysBuild(env.Command(get_target("initial_step"), get_deps("initial_step"), build))

get_target returns the target based on a label, get_deps returns a list of deps based on a label

build is defined as follows:

def build(target, source, env):

raise NameError('die')

when I run scons like this: scons tar -nQ --tree=all --debug=explain

scons: rebuilding `/tmp/a' because AlwaysBuild() is specified

build(["/tmp/a"], ["/tmp/create_a.sh"])

but no error, the build just continues.

any idea how to debug this issue?

Thanks,

Dagg

_______________________________________________

Scons-users mailing list

[email protected]

https://pairlist4.pair.net/mailman/listinfo/scons-users

_______________________________________________ Scons-users mailing list [email protected] https://pairlist4.pair.net/mailman/listinfo/scons-users

_______________________________________________
Scons-users mailing list
[email protected]
https://pairlist4.pair.net/mailman/listinfo/scons-users