Re: Printing dependency tree when dependency cyle found?

I'll see if I can find some time to get the "--tree" output even when
there's a cycle.

On Wed, Sep 22, 2021 at 1:37 PM Bill Deegan <[email protected]>
wrote:

> Generally I start by commenting/reverting new changes.
> Sometimes that's the fastest way.
> Also sometimes accidentally swapped target/source can lead to such.
> Also files which depend on directories or vice versa can cause issues.
>
> On Wed, Sep 22, 2021 at 10:34 AM Bill Deegan <[email protected]>
> wrote:
>
>> yes.. ;)
>>
>> On Wed, Sep 22, 2021 at 8:50 AM Gary Oberbrunner <[email protected]>
>> wrote:
>>
>>> Hi folks; before I dig into this myself, has anyone worked on the
>>> situation where there's a dependency cycle, but you can't easily debug it
>>> because "--tree" only prints after a successful build?
>>>
>>> --
>>> Gary
>>> _______________________________________________
>>> Scons-users mailing list
>>> [email protected]
>>> https://pairlist4.pair.net/mailman/listinfo/scons-users
>>>
>> _______________________________________________
> Scons-users mailing list
> [email protected]
> https://pairlist4.pair.net/mailman/listinfo/scons-users
>


-- 
Gary

_______________________________________________
Scons-users mailing list
[email protected]
https://pairlist4.pair.net/mailman/listinfo/scons-users