Re: FormEncode i18n translation integration in TurboGears

Gregor Horvath <[email protected]>
Newsgroups gmane.comp.web.turbogears,gmane.comp.python.formencode
Organization Ing. Gregor Horvath, Industrieberatung & Softwareentwicklung
Message-ID <[email protected]> 
Gregor Horvath schrieb:
> 
> 
> Is this concept OK?
> 
> The protoype works.
> If it's OK I am going to make a patch to TG's trunk and apply the
> changes to http://svn.colorstudy.com/FormEncode/branches/gettext-enabled/

I have just submitted a patch to:

http://trac.turbogears.org/turbogears/ticket/1136

Would be nice if someone could test this.

Thanks for the translations of formencode so far.
There are also some transalations in TurboGears to do. (see Patch)

Would be nice if those get translated too.

--
Greg

--~--~---------~--~----~------------~-------~--~----~
You received this message because you are subscribed to the Google Groups "TurboGears" group.
To post to this group, send email to [email protected]
To unsubscribe from this group, send email to [email protected]
For more options, visit this group at http://groups.google.com/group/turbogears
-~----------~----~----~----~------~----~------~--~---
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.