Re: PIL 1.1.7 binary for python 2.4
Jack Uretsky <[email protected]>
| Newsgroups | gmane.comp.python.image |
|---|---|
| Message-ID | <[email protected]> |
Thanks. I'n not seeing why that helps. I did Finder-File-Find-SDK and got 156 items. Im not sure what to do next Regards, Jack "Trust me. I have a lot of experience at this." General Custer's unremembered message to his men, just before leading them into the Little Big Horn Valley On Sat, 14 Nov 2009, Bill Janssen wrote: > OK, and is that Python 2.6 the one that comes with Snow Leopard? > > That should pin it down. The question here is, why is your system > trying to use the 10.4 SDK, instead of the 10.6 SDK? The only thing I > can think of is that you are using a non-Apple-supplied Python, which > was built against the 10.4 SDK, so it's trying to use that to build PIL, > too. > > Bill > > > Jack Uretsky <[email protected]> wrote: > >> Hi- >> Xcode - 3.2 (bundled with Mac OS upgrade software) >> Python 2.6 >> Mac OS X 10.6.1 (Snow Leopard) >> >> "Trust me. I have a lot of experience at this." >> General Custer's unremembered message to his men, >> just before leading them into the Little Big Horn Valley >> >> >> >> >> On Fri, 13 Nov 2009, Bill Janssen wrote: >> >>> Need more details. What version of OS X, what version of Python, what >>> version of Xcode? >>> >>> Bill >>> >>> Jack Uretsky <[email protected]> wrote: >>> >>>> Hi- >>>> Perhaps you can answer, at least, the second question. In >>>> what file do I find the gcc? >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> >>>> 1. What is my Xcode problem? When I run >python2.6 setup.py build >>>> I get: running build >>>> running build_py >>>> running build_ext >>>> --- using frameworks at /System/Library/Frameworks >>>> building '_imaging' extension >>>> Compiling with an SDK that doesn't seem to exist: >>>> /Developer/SDKs/MacOSX10.4u.sdk >>>> Please check your Xcode installation >>>> >>>> 2. this is followed by the line >>>> >>>> gcc -arch ppc -arch i386 -isysroot /Developer/SDKs/MacOSX10.4u.sdk >>>> -fno-strict-aliasing -fno-common -dynamic -DNDEBUG -g -O3 -DHAVE_LIBZ - >>>> >>>> In what file do I find this line so I can make the recommended correction? >>>> >>>> >>>> >>>> >>>> >>>> "Trust me. I have a lot of experience at this." >>>> General Custer's unremembered message to his men, >>>> just before leading them into the Little Big Horn Valley >>>> >>>> >>>> >>>> >>>> _______________________________________________ >>>> Image-SIG maillist - [email protected] >>>> http://mail.python.org/mailman/listinfo/image-sig >>> >> _______________________________________________ >> Image-SIG maillist - [email protected] >> http://mail.python.org/mailman/listinfo/image-sig > _______________________________________________ Image-SIG maillist - [email protected] http://mail.python.org/mailman/listinfo/image-sig