Re: window 7 and PIL 1.1.7
Fredrik Lundh <[email protected]>
| Newsgroups | gmane.comp.python.image |
|---|---|
| Message-ID | <[email protected]> |
32-bit or 64-bit Windows 7 (and Python)? The PythonWare builds are all 32-bit.
PIL uses the standard Python binary installers, so you might want to
look for solutions in other Python forums as well.
And if nothing else helps, there's always this:
http://effbot.org/zone/python-register.htm
(which may or may not do the right thing on Windows 7; haven't tested,
but I seem to remember that people have used it successfully on Vista)
</F>
On Sun, Mar 14, 2010 at 3:40 AM, Edward Cannon <[email protected]> wrote:
> I just got a new windows 7 machine. I installed python 2.6 and it
> works just fine. I downloaded the PIL 1.1.7 installer and I get the
> following error "python 2.6 required, which was not found in the
> registry." Any ideas?
> Edward
> Unicorn School
> _______________________________________________
> Image-SIG maillist - [email protected]
> http://mail.python.org/mailman/listinfo/image-sig
>
_______________________________________________
Image-SIG maillist - [email protected]
http://mail.python.org/mailman/listinfo/image-sig