Re: Installing libjpeg
Jack Uretsky <[email protected]>
| Newsgroups | gmane.comp.python.image |
|---|---|
| Message-ID | <[email protected]> |
Thanks. I believe I have Macports installed. Here's what I get on the first command: Macintosh-2:~ jackuretsky$ sudo port install libjpeg Password: sudo: port: command not found Further suggestions? Regards, Jack "Trust me. I have a lot of experience at this." General Custer's unremembered message to his men, just before leading them into the Little Big Horn Valley On Sat, 12 Jun 2010, Christopher Barker wrote: > Jack Uretsky wrote: >> Hi- >> I'm a newcomer, about to try to install PIL. I'm running OS X snow >> leopard pm am intel Mac. I'm at the point where I've downloaded the 4 >> files mentioned in the README ( >> libjpeg62 >> zlib1g >> libfreetype6 >> liblcmsl) >> but don't know what to do with them. > > I suggest one of two options: > > 1) Use the python.org python, and the binary recently posted to this list. > > > 2) use macports to compile the dependencies: > > a) install macports > b) $ sudo port install libjpeg > c) $ sudo port install lcms > d) $ sudo port install freetype > > e) python setup.py build > f) python setup.pyu install > > > > -CHB > > > > > -- > Christopher Barker, Ph.D. > Oceanographer > > Emergency Response Division > NOAA/NOS/OR&R (206) 526-6959 voice > 7600 Sand Point Way NE (206) 526-6329 fax > Seattle, WA 98115 (206) 526-6317 main reception > > [email protected] > _______________________________________________ Image-SIG maillist - [email protected] http://mail.python.org/mailman/listinfo/image-sig