Re: Cannot Load Pixel Information From PNG Image
Christopher Barker <[email protected]>
| Newsgroups | gmane.comp.python.image |
|---|---|
| Message-ID | <[email protected]> |
On 1/5/11 11:50 PM, Karol Krizka wrote: >> It just lookslike you have an indexed image, instead of an RGB one - >> Just print out your >> "im.mode" to get shure - >> > > print im.mode > 'L' > > Hmm, that seemed to have been the problem... yup. > For those interested, I now managed to create an RGB image using the > following command: > convert house.ppm png24:house.png you could have converted to RGB inside PIL, as well. -Chris -- Christopher Barker, Ph.D. Oceanographer Emergency Response Division NOAA/NOS/OR&R (206) 526-6959 voice 7600 Sand Point Way NE (206) 526-6329 fax Seattle, WA 98115 (206) 526-6317 main reception [email protected] _______________________________________________ Image-SIG maillist - [email protected] http://mail.python.org/mailman/listinfo/image-sig