Re: Packaging with sip5
Antonio Rojas <[email protected]>
| Newsgroups | gmane.comp.python.pyqt-pykde |
|---|---|
| Message-ID | <4159377.yL4AYCl3r7@arojas> |
El viernes, 13 de diciembre de 2019 11:48:38 (CET) Phil Thompson escribió: > On 13/12/2019 06:51, Antonio Rojas wrote: > > El jueves, 12 de diciembre de 2019 23:38:41 (CET) Phil Thompson > > escribió: > >> On 12/12/2019 22:29, Antonio Rojas wrote: > >> > Hi, > >> > What are the equivalents of 'make' and 'make install DESTDIR=foo' > >> > with sip5? For packaging it is important to have distinct build and > >> > install steps, and the final target install dir may not be available > >> > during the build step. Building pyqt with 'sip-build' still tries to > >> > write to the target dir - which fails if it is not writtable. > >> > >> If you run 'sip-build -h' you will see there is a '--no-make' option. > >> > >> Phil > > What did you do with SIP v4? The generated Makefile should be very > similar. With SIP4 I did: ./configure.py make make install DESTDIR=foo The first two commands don't do anything outside the build tree, only the last one cares about the target install dir. The same commands work with sip5, but IIUC configure.py is deprecated and one should use sip-build now. What I'm looking for is a way to build pyqt inside the build tree (similar to the old configure.py + make) that doesn't try to write to the target dir. _______________________________________________ PyQt mailing list [email protected] https://www.riverbankcomputing.com/mailman/listinfo/pyqt