Re: Packaging with sip5
Antonio Rojas <[email protected]>
| Newsgroups | gmane.comp.python.pyqt-pykde |
|---|---|
| Message-ID | <3737393.6at3ajpIVQ@arojas> |
El viernes, 13 de diciembre de 2019 12:22:50 (CET) Phil Thompson escribió: > > With SIP4 I did: > > ./configure.py > > make > > make install DESTDIR=foo > > The first two commands don't do anything outside the build tree, only > > the last one cares about the target install dir. > > > > The same commands work with sip5, but IIUC configure.py is deprecated > > and one should use sip-build now. What I'm looking for is a way to > > build pyqt inside the build tree (similar to the old configure.py + > > make) that doesn't try to write to the target dir. > > As I said, the Makefile should be very similar so invoke make in the > same way. > > Phil > Yes, I got that. The probem here is the "doesn't try to write to the target dir" part, because as I said above, 'sip-build --no-make' fails if the target dir is not writable (as it is the case for us: we have separate build and install stages and the target install dir is not writable during the build stage). So I can't simply replace configure.py with 'sip-build --no-make' - this command fails so I don't even get the chance to run make. _______________________________________________ PyQt mailing list [email protected] https://www.riverbankcomputing.com/mailman/listinfo/pyqt