Re: Compiling via setuptools

On Sun, 21 Dec 2008 15:20:37 -0500, "Phillip J. Eby"
<[email protected]> said:
> At 12:51 PM 12/21/2008 +0000, [email protected] wrote:
> >When I use the next command in my home system:
> >
> >   $ python setup.py develop
> >
> >Pyrex compiles the '.pyx' file without any problem. But after of
> >uploading it to Pypi, and when is installed via 'easy_install' it
> >doesn't builds any more. (I had to upload the '.c' file compiled on my
> >system)
> 
> This is normal: the person receiving your distribution must either 
> have Pyrex, or you must include the .c file.  I normally just check 
> the generated .c files into revision control, so that setuptools will 
> automatically send them out in my source distributions.
> 
> (It can be a good idea to do this even if your target audience has 
> Pyrex, since it gives you better control over which version of Pyrex 
> gets used for the building.)
> 
Then it's a Setuptools issuse because with the next options the system
already has Pyrex:

  setup_requires='Pyrex',
  install_requires='Pyrex',

Thanks anyway