Re: [spe-users] Newbie: Can't start SPE

http://pythonide.stani.be
http://pythonide.stani.be/manual/html/manual.html
http://pythonide.stani.be/blog/sm_donate
--


Dear Bryn,
I think you should try to run spe again with wxpython 2.7.2.0 but in
debug mode or at least from a command shell.  I just updated my wxpython
from version 13 to version 20 with python 25 and it's working with our
any issues.
Jose

Bryan White wrote:
> http://pythonide.stani.be
> http://pythonide.stani.be/manual/html/manual.html
> http://pythonide.stani.be/blog/sm_donate
> --
>
>
>   
>
> ------------------------------------------------------------------------
>
> Nevermind - figured it out 30 seconds after emailing... :( Had to go
> find an older version of wxPython. Sorry for the noise.
>
> On 11/11/06, *Bryan White* < [email protected]
> <mailto:[email protected]>> wrote:
>
>     Greetings, I just installed:
>
>     - Python 2.4.4
>     - wxPython 2.7.2.0 <http://2.7.2.0> unicode version for Py 2.4
>     - SPE 0.8.2
>
>     SPE won't launch; a white console comes up momentarilly scrolling
>     output too fast to read, then immediately closes.
>
>     Any tips for this likely common noob question would be appreciated,
>
>     Bryan
>
>
> ------------------------------------------------------------------------
>
> _______________________________________________
> Python-spe-users mailing list
> [email protected]
> https://lists.berlios.de/mailman/listinfo/python-spe-users
>