Re: Python 3 and FormEncode

Am 25.07.2016 um 13:18 schrieb Oleg Broytman:
 >   File "<stdin>", line 1, in <module>
 > NameError: name 'unicode' is not defined

Hi Oleg,

FormEncode 1.3 should run with Python 3, it uses 2to3. This error 
indicates that during installation the 2to3 tool did not run properly. 
Some have reported that this problem can be caused by cached wheels.

In FormEncode 2, 2to3 is not used any more because of such issues, but I 
think there is no official release of FormEncode 2 yet.

Anyway, if FormEncode 1.3 is installed properly, it should work.

-- Christoph


------------------------------------------------------------------------------
What NetFlow Analyzer can do for you? Monitors network bandwidth and traffic
patterns at an interface-level. Reveals which users, apps, and protocols are 
consuming the most bandwidth. Provides multi-vendor support for NetFlow, 
J-Flow, sFlow and other flows. Make informed decisions using capacity planning
reports.http://sdm.link/zohodev2dev