Re: wxGlade not updating existing code

I spent a lot of time going thru my source code today and assured myself
that all of the "# begin wxGlade:" and "# end wxGlade" lines are matched
and appropriately placed.

I also looked at the wxGlade code to see if I could find where the logic
that looked for code insertion points was so I could do some debugging in
that area but the multilanguage support makes it very abstract and thus
difficult to find where that happens.

I appreciate all you do in developing and supporting wxGlade. The user
interface of my project consists of one .py file and is about 8000 lines
long but obviously you don't have to understand it or run it. If you could
take a look at the issue I would be grateful. Let me know how to get the
files to you.

On Sat, Nov 12, 2022 at 4:23 AM Dietmar Schwertberger <
[email protected]> wrote:

> On 12.11.2022 00:35, William Luitje wrote:
> > What do you suggest that I try next? Is there debugging code built
> > into wxGlade that I can turn on? Is there some failure mechanism that
> > I am overlooking?
> If the markers are there, the only way to debug such issues is to step
> through with the debugger.
>
> If you want, you can mail me your project files and I will delete them
> after debugging.
>
> Regards,
>
> Dietmar
>
>
>
> _______________________________________________
> wxGlade-general mailing list
> wxGlade-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
> https://lists.sourceforge.net/lists/listinfo/wxglade-general
>

_______________________________________________
wxGlade-general mailing list
wxGlade-general-5NWGOfrQmneRv+LV9MX5uipxlwaOVQ5f@public.gmane.org
https://lists.sourceforge.net/lists/listinfo/wxglade-general