| Newsgroups |
gmane.comp.python.wxpython |
| Message-ID |
<[email protected]> |
Sorry for resurrecting this very old thread, but I have the same issue,
also on GTK. Are there any new insights to this problem?
Juampy schrieb am Donnerstag, 29. März 2012 um 22:31:06 UTC+2:
> The odd behavior is that it only happens around the "original value". Lets
> say you set the value on 25 with increments of 1. If you press the up arrow
> it will go: 25, 26, 27, 28, etc.. But if you press the down arrow it will
> go:* 25, 26 , 25* , 24,23,22, etc.
> Another odd thing is that it repeats its behavior every time you go
> through 25. For example, if you start on 25, and press the up arrow until
> you reach 28 and then go down, it will go: 28, 27, *26, 25, 26, 25*, 24,
> 23, 22, etc.
> It doesn't matter the increment of the arrow and/or the initial value. If
> you start on 10, with 0.2 increments, it will go: *10, 10.2, 10,* 9.8,
> 9.6, etc.
>
> I've also noticed that either reaching the max_val or min_val, or doing a
> "press and hold" on the arrow (so it will increase the value faster) makes
> the FloatSpin work as it should.
>
> I really think that this is GTK related, but in any case if you have a
> clue on how could I workaround this, would be really helpful.
>
> Best Regards,
>
>
> On Thursday, March 29, 2012 5:17:32 PM UTC-3, Juampy wrote:
>>
>> Hi Andrea,
>> I know this thread have quite some time, but I stomped into this now. Is
>> there any workaround to have it working on GTK?
>>
>> By the way, thanks for such great job on the AGW library.
>>
>> Regards,
>>
>> On Tuesday, June 2, 2009 11:22:43 PM UTC-3, Carlos Grohmann wrote:
>>>
>>> Hello all,
>>>
>>> I'm using Andrea's FloatSpin in an app, and it works fine but there is
>>> one small issue: if I set the initial value to, say, 3.5 (with steps
>>> of 0.5), and the first thing I do when I run the pregram is to
>>> decrease that value, it will go from 3.5 to 4.0, then 3.5 and then
>>> finally 3.0. If I run the program and try to increase the values,it's
>>> all good. Any hints?
>>>
>>> cheers
>>
>>
--
You received this message because you are subscribed to the Google Groups "wxPython-users" group.
To unsubscribe from this group and stop receiving emails from it, send an email to [email protected].
To view this discussion on the web visit https://groups.google.com/d/msgid/wxpython-users/d48d811c-0e90-4dbd-96b5-8920a3092209n%40googlegroups.com.