Re: command h5tov5d not found

On Fri, 19 May 2006, Peter wrote:
> I have installed h5utils. The command h5topng works well, but the 
> command h5tov5d is not found and I cannot convert .h5 files to .v5d 
> files.

When you configure h5utils, you need to specify --with-v5d=dir to tell it 
the location of the vis5d source directory.

(These days I tend to recommend MayaVi over Vis5d.)

> I also have trouble in installing vis5d. I have successfully 
> uncompressed vis5d-5.1.tar.Z. However, when I entered "uncompress 
> vis5d-data.tar.Z ", it said "no space left on device".  What is the 
> reason? Thanks a lot.

That means you are out of disk space.

Steven