mpb-mpi error
"Jun She" <[email protected]>
| Newsgroups | gmane.comp.science.photonic-bands |
|---|---|
| Message-ID | <[email protected]> |
The MPI implementation I used is LAM-7.1.2. The HDF5 version is hdf5-1.6.2 without MPI surport. when I run mpirun C mpb-mpi ..., the message below is showed. Outputting epsilon... ----------------------------------------------------------------------------- One of the processes started by mpirun has exited with a nonzero exit code. This typically indicates that the process finished in error. If your process did not finish in error, be sure to include a "return 0" or "exit(0)" in your C code before exiting the application. PID 4250 failed on node n4 (10.10.10.5) due to signal 11. ----------------------------------------------------------------------------- Could you give me some advice? Do I need to compile hdf5 with mpi? When I use two nodes, the message is the same. I can't do any simulation. Jun _______________________________________________ mpb-discuss mailing list [email protected] http://ab-initio.mit.edu/cgi-bin/mailman/listinfo/mpb-discuss