Re: Fwd: Re: telnet hangs on the sasl2 part

Op 5-6-2017 om 12:05 schreef Alexander Dalloz:
> Am 05.06.2017 um 11:48 schrieb Roelof Wobben:
>> I tried today with dovecot and I see the same problem.
>> Everything works fine till I enable sasl_auth.
>>
>> Somone still a idea ?
>>
>> Roelof
>
> Start from scratch.
>
> Postfix and cyrus-sasl-lib are installed by default on CentOS 7.
>
> Edit /etc/sasl2/smtpd.conf with
>
> pwcheck_method: auxprop
> mech_list: plain login
>
> Create your /etc/sasldb2 running
>
> saslpassd2 -u localhost roelof
>
> And finally enable SMTP AUTH for Postfix by
>
> postconf -e "smtpd_sasl_auth_enable=yes"
> systemctl restart postfix
>
> (Note: once finished these basics move on and enable SMTP AUTH only 
> for submission and remove it from SMTP port 25.)
>
> Alexander
>
>

The command saslpassd2 is not found. Also sasslpasswd2 is not found.
And I check on a fresh install and cyrus-sasl was not installed.

Roelof