Re: Fwd: Re: telnet hangs on the sasl2 part

Op 5-6-2017 om 13:02 schreef Alexander Dalloz:
> Am 05.06.2017 um 12:22 schrieb Roelof Wobben:
>> Op 5-6-2017 om 12:05 schreef Alexander Dalloz:
>>> Am 05.06.2017 um 11:48 schrieb Roelof Wobben:
>>>> I tried today with dovecot and I see the same problem.
>>>> Everything works fine till I enable sasl_auth.
>>>>
>>>> Somone still a idea ?
>>>>
>>>> Roelof
>>>
>>> Start from scratch.
>>>
>>> Postfix and cyrus-sasl-lib are installed by default on CentOS 7.
>>>
>>> Edit /etc/sasl2/smtpd.conf with
>>>
>>> pwcheck_method: auxprop
>>> mech_list: plain login
>>>
>>> Create your /etc/sasldb2 running
>>>
>>> saslpassd2 -u localhost roelof
>>>
>>> And finally enable SMTP AUTH for Postfix by
>>>
>>> postconf -e "smtpd_sasl_auth_enable=yes"
>>> systemctl restart postfix
>>>
>>> (Note: once finished these basics move on and enable SMTP AUTH only 
>>> for submission and remove it from SMTP port 25.)
>>>
>>> Alexander
>>>
>>>
>>
>> The command saslpassd2 is not found. Also sasslpasswd2 is not found.
>> And I check on a fresh install and cyrus-sasl was not installed.
>>
>> Roelof
>
> I said cyrus-sasl-lib is installed as a base package on CentOS 7. And 
> that package ships /usr/sbin/saslpasswd2 (sorry for my typo saslpassd2).
>
> Are you really running CentOS or is it some kind of crippled VPS 
> install of a provider who just claims it is CentOS?
>
>
>
>
>


I did all the steps you mentioned on a fresh install of Centos 7 on a 
Hyper V box,
And still when I do telnet localhost 25 and then ehlo localhost I do not 
see any respons.

Roelof