Problem setting up FireQOS on A-DSL with PPPoE
Florian Schröck <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.firehol.user |
|---|---|
| Message-ID | <CAJduyan=3on-yXo=Sq4_quwRSUGyAgbGn_xFbe4EEYjf4-SB1g@mail.gmail.com> |
Hello,
I was looking for a traffic shaping solution for my home network and i love
firehol i stumbled upon fireqos. To get started i just pasted the complete
example from the howto and changed the DEVICE=ppp0 and the speeds.
ppp0 is my PPPoE device on my raspberry pi from a german DSL provider. But
at the start i just get the errors below. Can somebody point me in the
right direction?
Thank you!
FireQOS $Id: 3bd5794f2e29d2748784acd5d7810d54ba1e99e2 $
(C) 2013 Costa Tsaousis, GPL
: interface ppp0 world-in input rate 14000kbit adsl local pppoe-llcCannot
find device "ppp0-ifb"
FAILED: Cannot bring device ppp0-ifb UP.
FAILED TO ACTIVATE TRAFFIC CONTROL.
Clearing failed interface: world-in (ppp0 input => ppp0-ifb)...
ppp0-ifb: ./fireqos.in: line 334: interface_inout: command not
found
cleared traffic control
ppp0-ifb: removed IFB device
No traffic control is operational by FireQOS
bye...
_______________________________________________
Firehol-support mailing list
[email protected]
http://lists.firehol.org/mailman/listinfo/firehol-support