Re: rate values in FireQOS with overhead or without?
"Tsaousis, Costa" <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.firehol.user |
|---|---|
| Message-ID | <CANL+VpYn1MxRykMYeoQwgQfkrGtT0Stur7unNmi_7XRSh1VHCg@mail.gmail.com> |
Hi, the rates should be the final, with overheads. If you compare tc values to actual network values you will se the difference. The network interface reports smaller numbers. Costa On Sun, May 4, 2014 at 5:26 PM, Phineas Gage <[email protected]> wrote: > When entering rates for a class in FireQOS, should they be with packet > overheads or without? > > When a VOIP call is active in my environment (codec unknown) I see a rate > of 66 show up in the VOIP class, pretty consistently. What I’m trying to > figure out is if this is the rate I should have configured in my > fireqos.conf (maybe with some padding), or if it should be something > smaller, without overhead. > > _______________________________________________ > Firehol-support mailing list > [email protected] > http://lists.firehol.org/mailman/listinfo/firehol-support > _______________________________________________ Firehol-support mailing list [email protected] http://lists.firehol.org/mailman/listinfo/firehol-support