Re: message from xt_physdev when running firehol in bridge configuration
"Tsaousis, Costa" <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.firehol.user |
|---|---|
| Message-ID | <CANL+VpYW8VEoxo+eD6UiP4noUwQDPN4oiJLd6SaC94+E7iY42g@mail.gmail.com> |
Hi Phineas, Can you trace it down? Are you using physin/out on non-bridged traffic only? Try to run a few commands by hand to check which ones complain. Regards, Costa On Tue, Nov 18, 2014 at 3:59 PM, Phineas Gage <[email protected]> wrote: > Hi, > > I’m getting this message many times in my syslog when running firehol: > > xt_physdev: using --physdev-out in the OUTPUT, FORWARD and POSTROUTING chains for non-bridged traffic is not supported anymore. > > This happens only when I use either the ‘physin’ or ‘physout’ keywords on either my router definitions or route subcommands for the br0 (bridge) interface. If I omit those keywords it doesn’t happen. Can I still use ‘physin’ and ‘physout’ with my bridge somehow? They’re useful for knowing which direction the traffic is going through the bridge... > > Phineas > > _______________________________________________ > Firehol-support mailing list > [email protected] > http://lists.firehol.org/mailman/listinfo/firehol-support _______________________________________________ Firehol-support mailing list [email protected] http://lists.firehol.org/mailman/listinfo/firehol-support