Re: text "ERROR" shown by "fireqos status" for first class in class group

Hi Phineas,

I don't see your config file attached.
Please attach it. I'll try to run it to figure out what is happening.

Costa


On Sun, Apr 19, 2015 at 12:05 PM, Phineas Gage <[email protected]> wrote:
> Hi,
>
> In FireQOS 2.0.2, When I run "fireqos status <dev>” (where <dev> is either eth1-in or eth1-out), I see the text ERROR for the first class in a class group. So the output looks like this:
>
> -----
> FireQOS 2.0.2
> (C) 2013-2014 Costa Tsaousis, GPL
>
> eth1-out: eth1 output => eth1, type: , overhead:
> Rate: 100000Kbit/s, min: 12Kbit/s
> Values in Kbit/s
>
>   CLASS     lan    adsl ad/voip ad/busi ad/defa ad/conf ad/priv default
> CLASSID    1:11    12:1   12:11   12:12 12:5012   12:14   12:15  1:5000
>  COMMIT   50000     360      72      54      54      54      54      12
>     MAX   50000     360     360     360     360     360     360  100000
>
> PRIORIT       1       0       0       1       4       2       3       1
>   QDISC fq_code fq_code fq_code fq_code fq_code fq_code fq_code fq_code
>
>  color code (packets):  backlog  |  dropped  |  delayed  |  requeued
>  Class Utilization on eth1-out (eth1 output => eth1) - values in Kbit/s
>   TOTAL     lan    adsl ad/voip ad/busi ad/defa ad/conf ad/priv default
>      19       2      15   ERROR       -       1       -      14       2
>      41       4      37   ERROR       -       -       -      37       -
> ——
>
> Looking at the fireqos script, it’s line 3022, in FireQOS 2.0.2, that decides to print ERROR when the value of $y is zero length, for some reason.
>
> Here are a few things I’ve noticed about it:
>
> - If the first class in my class group is “default”, it doesn’t happen. That’s the way I had it before, but I need to make a change now.
> - If I change the rates on my classes and groups slightly, the ERROR can go away, but it seems inconsistent what changes produce what result.
> - If I switch the order such that for example “business” is the first class in the group instead of “voip” then “business” is the one that sees the error.
>
> I attached my fireqos.conf, with variable definitions removed, as well as the output from “tc class show dev eth1”, in case it’s useful.
>
> Any ideas?
>
> Regards,
> Phineas
> _______________________________________________
> Firehol-support mailing list
> [email protected]
> http://lists.firehol.org/mailman/listinfo/firehol-support
_______________________________________________
Firehol-support mailing list
[email protected]
http://lists.firehol.org/mailman/listinfo/firehol-support