Re: blacklist command fails

Hi,

use:

ipv4 blacklist ...

or

blacklist4 ...

It tried to apply it to IPv6 too.

Costa


On Wed, May 11, 2016 at 11:35 AM, Russel Winder <[email protected]>
wrote:

> I tried putting the line:
>
> blacklist full 59.45.79.21
>
> into firehol.conf but this leads to the error below. Is this to be
> expected? Am I just doing something wrong?
>
>
> ERROR   : # 1.
> WHAT    : A runtime command failed to execute (returned error CANNOT
> APPLY IN FAST MODE).
> SOURCE  : FIN
> COMMAND : /sbin/ip6tables-restore \</var/run/firehol/firehol-
> XoMqpfVIsq/firehol-out.sh.fast6
> OUTPUT  :
>
> ip6tables-restore v1.6.0: host/network `59.45.79.21' not found
> Error occurred at line: 9
> Try `ip6tables-restore -h' or 'ip6tables-restore --help' for more
> information.
>
> Offending line:
> -A INPUT -s 59.45.79.21 -j BLACKLIST.bi.1.in
>
>  FAILED
>
>
>
> --
> Russel.
>
> =============================================================================
> Dr Russel Winder      t: +44 20 7585 2200   voip:
> sip:[email protected]
> 41 Buckmaster Road    m: +44 7770 465 077   xmpp: [email protected]
> London SW11 1EN, UK   w: www.russel.org.uk  skype: russel_winder
>
> _______________________________________________
> Firehol-support mailing list
> [email protected]
> http://lists.firehol.org/mailman/listinfo/firehol-support
_______________________________________________
Firehol-support mailing list
[email protected]
http://lists.firehol.org/mailman/listinfo/firehol-support