Re: ng0 snmp could not read interface

Mohammed Ismail wrote:
> This is the output when I followed the instruction, 
> xx.xxx.com
> Interfaces : -m: not found
> *-----
> IP Addresses : .!.
> IPv6 Addresses :
> Temperatures :
>
> Then I changed In /discovery/interfaces.php 
> $cmd  = $config['snmpbulkwalk'] . " -m IF-MIB -O nsq -" . $device['snmpver']
> . " -c " . $device['community'] . " " .
> $device['hostname'].":".$device['port'];
>
> ######<<< made it >>> 'snmpwalk'
>   
Please put :

$config['snmpbulkwalk'] = "/usr/bin/snmpbulkwalk";

Into config.php

Observer from 0.6 now uses snmpbulkwalk for walking interface tables.

> $cmd  = $config['snmpwalk'] . " -m IF-MIB -O nsq -" . $device['snmpver'] . "
> -c " . $device['community'] . " " . $device['hostname'].":".$device['port'];
> ##
> Now it is reading lo0, enc0 but no ng at all
> Also I added the new config like and put # in front of old $config['bad_if']
> And the output is like 
> xx.xxx.com
> Interfaces : ++++X
> IP Addresses : +A!.
> IPv6 Addresses :
> Temperatures :
> ##
> Polling xx.xxx.com ( device_id 8 )
>
> Pings : yes :)
> SNMP : yes :)
> Polling temperatures
> Polling device network statistics...
> Polling interfaces
> Looking at xl0 on xx.xxx.com
> Looking at xl1 on xx.xxx.com
> Looking at lo0 on xx.xxx.com
> Looking at enc0 on xx.xxx.com
>
> It started to read all virtual interfaces including ng0-ng253 I guess 
> Suddenly I got 411 interfaces instead of 77 I had before. Reading 14
> m0n0wall.
> ,, 
> I am sorry I don't understand php codes, but I really need the ng0 interface
> so bad, so I can receive logs each under it's m0n0wall.
> As logs are being sent through ng0 IP address.
>   
I see only these interfaces via SNMP from m0n0 :

root@alpha:~# snmpwalk -v2c -c <THING> jersey.memetic.org ifDescr
IF-MIB::ifDescr.1 = STRING: vr0
IF-MIB::ifDescr.2 = STRING: vr1
IF-MIB::ifDescr.3 = STRING: vr2
IF-MIB::ifDescr.4 = STRING: lo0
IF-MIB::ifDescr.5 = STRING: enc0
IF-MIB::ifDescr.6 = STRING: ng0
IF-MIB::ifDescr.7 = STRING: gif0

What do you see on an snmpwalk? Can you show me your config.php?

adam.