Re: IPSEC X 2 WAN

I don't think there is a way Richard, a work around I use on other
equipment is a 2nd tunnel, and then a weighted route(s) pointing to
the 2nd tunnel for a backup network, unless you have a routing
protocol running :)

Charles

On Mon, Aug 10, 2009 at 7:42 AM, Marsh, Richard<[email protected]> wrote:
> Hi All,
>
> Wondered if you could help me....
>
> I have m0n0wall running in production with about 15 ipsec tunnels to branch offices all over the country. I have installed multiwan firewalls at branch office end, and wondered if there is a way to tell the Monowall that there is more than one public IP to terminate the ipsec tunnel on... I have a leased line and an adsl at the clients end, so ideally I would like the Monowall to connect to the wan ip of the leased line for the ipsec tunnel, but if it's down (like today) I would like it to connect to the adsl (without me having to change wan IPs in the Monowall)... Is there secondary IP or something I am missing.
>
> Thanks for any help /advise.
>
> Rich
>
> Richard Marsh
> BSc (Hons), MBCS, VCP, WCSP, VTSP
>
> COMPUTING INFORMATION SYSTEMS LIMITED
> Gainfield House, Gainfield
> Faringdon
> Oxfordshire
> SN7 8QQ
>
> Tel:        01367 870 555
> Mob:     07970 097 446
> DDI:      01367 700 551
>
> The information contained in this e-mail is confidential and is intended only for the addressee. If you have received this e-mail in error please notify us immediately and then destroy it. We make every effort to keep our network free from viruses, you do need to check this e-mail and any attachments to it as we can take no responsibility for any computer virus which might be transferred by way of this e-mail.
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>
>