RE: Nexcom NSA 1083

OK - at this point I have gotten the .img file loaded on the CF card - the unit booted but halted and indicated that the device containing the config.xml file could not be found.

Still looking


-----Original Message-----
From: David Johnson [mailto:[email protected]] 
Sent: Tuesday, August 25, 2009 11:57 AM
To: Lee Sharp; [email protected]
Subject: RE: [m0n0wall] Nexcom NSA 1083

Failing to boot.......may have been the way I was imaging the CF card

Used my intel mac first - now trying with RHEL4.....will see how that goes.

I have been through the BIOS settings and think I have everything correct.

I will update after I try the generic image.

Thanks


-----Original Message-----
From: Lee Sharp [mailto:[email protected]] 
Sent: Tuesday, August 25, 2009 11:51 AM
To: [email protected]
Subject: Re: [m0n0wall] Nexcom NSA 1083

David Johnson wrote:
> We have a NSA 1083 appliance laying around and I would like to load m0n0wall on the box - but many tries have been unsuccessful
> 
> Which version should I be attempting to load?
> 
> This unit has only a CF card - 256MB but I can install a 2.5 or 3.5 inch HDD if necessary - just would prefer to use the CF......
> 
> Any advice will be appreciated!

Generic PC on the CF should work.  What problems are you having?

			Lee

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]



---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]