Re: NAT based on source IP?
Patrick Lidstone <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <[email protected]> |
2009/9/10 Melvin <[email protected]> > Patrick Lidstone wrote: > >> I'm looking for a hand with m0n0 configuration, hopefully this is the >> right >> place to ask - if not apologies in advance! >> >> I have a single static IP address with a single network behind the >> firewall, >> using NAT. >> >> I need to route incoming requests on a fixed port to different servers >> behind the firewall based on source IP. i.e. >> >> I need to route incoming requests from a known source IP on port X to >> server >> A on port Y, and requests from any other IP address on port X to server B >> on >> port Y. >> >> Whilst I can set up firewall rule to route by source IP (and port) to >> server >> A and server B, I can't find a way to set up the NAT rules so that they >> are >> applied on the basis of source IP. >> >> Is what I am trying to do just "wrong" or otherwise impossible? Is there >> any >> other way of approaching the problem? The obvious solution - changing the >> clients so that the requests from a known source use a different port - is >> not an option unfortunately. >> >> Many thanks >> Patrick >> >> >> > The answer probably depends on what the protocol/ports are in this case. > What kind of traffic are you dealing with? > > UDP (IAX2) Patrick