Re: Deny access to GUI

David Burgess <[email protected]> Thu, 14 Jan 2010 14:02:59 -0700

Newsgroups	gmane.comp.security.firewalls.m0n0wall
Message-ID	<[email protected]>

On Thu, Jan 14, 2010 at 1:26 PM, Brieseneck, Arne, VF-Group
<[email protected]> wrote:

> GUI is supposed to run only on LAN interface, but is accessible from
> everywhere.

When you create a new rule in the firewall it only applies to new
connections. You may have done it correctly but OPT1 still has access
if a connection existed prior to applying the new rule. Try resetting
the firewall state table and test again.

db