Traffic Shaper Question

Hi everybody, 

I have been using traffic shaper for only limiting the download/upload speed
for each user, so I used to creat a pipe let us say 256kbps and I put mask
on distention so it will creat a pipe for each IP/ address the rule apply
for. 

On the rules page I go like this 

Wan incoming src.any dis.LANsubnet 

Wan outgoing src.LANsubnet dis.any 

This would put each user in 256kbps pipe for download and 64kbps for upload.


I know that 1st rule maches it would get applied for the host. 

So if I used traffic shaper on the LAN interface instade of WAN 

To limit each user at 256kbps 

And in the same time limit the total download to 3MB

Can I put a rule for that on the WAN interface, what I am trying to say Is 

Does traffic shaper check rules for each interface individually 

In other way, 

If I put some rules on LAN interface to limit the download speed for each
user at 256kbps 

Can I put a rule after this rule to limit the overall download to 3000kbps
and the rule applies for WAN 

Is it going to work ?

>> 

Rules : 

Int.        Direction.          Src.                  Dist.
Target

LAN      Out                   any                   LAN.NET
256/kbps/DN

LAN      IN                     LAN.NET           any
64/kbps/UP

WAN    IN                     any                   LAN.NET
3000/kbps/DN

WAN    Out                   LAN.NET           any
800/kbps/UP

 

Pipes:

Bandwidth                     Mask

256kbps                        Dist.

64kbps                          Src.

3000kbps                      none

800kbps                        none

 

Best Regards.

Mohammed Ismail