Re: 1.3 and strict NAT?

Ryan Crisman <[email protected]>
Newsgroups gmane.comp.security.firewalls.m0n0wall
Message-ID <[email protected]>
Yeah thats cool, anything to help people with a similar problem.

Ryan Crisman
MIS/IT/Webmaster Manager
Ten-Tec, Inc.
1185 Dolly Parton Parkway
Sevierville TN, 37862


On Tue, Feb 9, 2010 at 8:38 AM, Mike Dent <[email protected]> wrote:

> Thanks Ryan,
> I ended up moving to pfSense on my Soekris box and can now run 2 x
> Xbox 360 with open NAT.
> I've put a link back to your article from my blog article, hope that is ok.
>
> Thanks again,
> Mike
> http://www.g6phf.co.uk/
>
>
> On 9 February 2010 13:32, Ryan Crisman <[email protected]> wrote:
> > I had this same problem myself with XBOX live and after some research I
> get
> > Open Nat now.  I wrote a how to and placed it on my site, see link below.
> > How to Get XBOX Live working on m0n0wall
> > http://rcrisman.net/article/5/how-to-get-xbox-live-working-on-m0n0wall
> > Ryan Crisman
> > MIS/IT/Webmaster Manager
> > Ten-Tec, Inc.
> > 1185 Dolly Parton Parkway
> > Sevierville TN, 37862
> >
> >
> > On Thu, Feb 4, 2010 at 8:12 AM, Mike Dent <[email protected]> wrote:
> >>
> >> On 4 February 2010 12:40, Dennis Karlsson <[email protected]>
> >> wrote:
> >> > *1. Enable advanced outbound NAT
> >> I've tried that. I assume I need to create a mapping for my internal
> >> subnet in the section below
> >> where this is enabled?
> >>
> >> > **2. Disable port mapping*
> >> I don't have any NAT rules defined which would affect the xbox.
> >>
> >> Thanks
> >>
> >> Mike
> >>
> >>
> >>
> >> > *
> >> > *
> >> > On 2010-02-04 13:05, Mike Dent wrote:
> >> >>
> >> >> Hi,
> >> >> I've been using m0n0wall for several years now. Most recently I was
> on
> >> >> 1.2(something). My two lads who both use XBOX 360 reported that NAT
> >> >> was showing
> >> >> as 'moderate' from their xboxes. This usually does not cause a
> problem.
> >> >>
> >> >> However recently I upgraded to m0n0wall 1.3 and now NAT shows as
> >> >> strict?
> >> >>
> >> >> I can't see any changes in the config that may have caused this to
> >> >> happen.
> >> >> I realise that m0n0 does not support upnp for good reason but if I
> >> >> could get things working
> >> >> back as how it was, ie moderate nat, then I would be happy.
> >> >>
> >> >> Many thanks
> >> >>
> >> >> Mike
> >> >>
> >> >> ---------------------------------------------------------------------
> >> >> To unsubscribe, e-mail: [email protected]
> >> >> For additional commands, e-mail: [email protected]
> >> >>
> >> >>
> >> >
> >>
> >> ---------------------------------------------------------------------
> >> To unsubscribe, e-mail: [email protected]
> >> For additional commands, e-mail: [email protected]
> >>
> >
> >
>
lmpx.com only provides a reader for public news (NNTP) servers. It is not affiliated with the servers or forums shown here and is not responsible for the content of articles, which is written by their respective authors.