Re: WAN blocked and should not be
"Andrew Tillman" <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <[email protected]> |
NAT is turned off. Both IPs are on the same subnet because of the existing internal network. If I just unhook the WAN will captive portal still work if monowall is plugged into the switch? Thank you :) -- Andrew Tillman Tech Specialist Lee County Library Leesburg, GA 31763 [email protected] > Andrew Tillman wrote: >> >> I am setting up a captive portal and already have in place a hardware >> firewall, so I need the firewall completely disabled. I am only after >> the >> captive portal service available. >> >> Setup is: >> Internet >>>> hardware firewall >> switch >> all internal >> devices >> >> All LAN traffic seems to be fine but WAN traffic is >> being blocked. >> >> LAN IP = 192.168.11.45 >> WAN IP = >> 192.168.11.46 > > Both IPs are on the same subnet. Thsi will not work. Also is NAT > turned off? > > Lee > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > >