Re: Hotspot Billing
Joe <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <[email protected]> |
Nevermind. I found the document here: <http://m0n0.ch/wall/tools/How%20to%20load%20m0n0wall%20onto%20a%20WatchGuard%20Firebox%20x500.pdf> Thanks! On 02/26/2010 08:28 PM, Joe wrote: > Frederic, > > Can you describe how you loaded m0n0wall onto the Watchguard HW? > I may be able to get one of these units, so knowing the process would > be very helpful! > > Thanks, > Joe > > On 02/26/2010 07:42 PM, Frederic J. Breitwieser wrote: >> Greetings, >> >> >> >> I successfully got my m0m0wall working on Watchguard hardware, one port >> assigned as a "captive portal" and my EnGenius 600mw wifi AP's are >> plugged >> into that via a 10/100 switch. >> >> >> >> If devices are in the approved MAC list they go right through >> bypassing the >> portal and devices that are not need to enter a username/password. >> >> >> >> I have not experimented with FreeRadius and that's the next part of the >> project. One of the things I'd like to do is turn this into a >> customer-facing hotspot, where I can accept credit cards for hourly and >> daily use. >> >> >> >> Might any of you folks on this list done this using m0n0wall? I've >> found >> several how-to's to do this with other things but I have to say I >> really, >> really like m0n0wall and would prefer, if possible, to keep using it for >> this purpose. >> >> >> >> Any ideas welcomed, thanks! >> >> >> >> > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > >