Re: DHCP testing
Steven Nusser <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <[email protected]> |
On Thu, May 6, 2010 at 12:53 AM, Chris Buechler <[email protected]> wrote: > > On Wed, May 5, 2010 at 11:04 PM, Frederic Breitwieser > <[email protected]> wrote: > > Not exactly a m0n0wall question, but you folks may have a good > > recommendation. > > > > I'm looking for a piece of freeware that would simulate a DHCP request from > > my m0n0wall, so I can look at the result and verify that the PXE server I > > specified is actually being passed. > > > > Why not actually use m0n0wall? I think for that I'd setup a m0n0wall > VM in VMware, and check the DHCP request and response in Wireshark on > the host system. > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > Also, if you have access to a managed switch, you could set up a monitored port that receives all traffic from all ports. You could then plug a computer running Wireshark into this port.