RE: no reaction after installation
"Thompson, Andrew" <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <5019A65D53E8B84F942FFC17160B4DD06EFCB36781@alligator> |
Get out your serial cable, plug it into the Alix and see what the console says. There is no other way of finding out what is going on if you have no IP connectivity. PC Engines supply the required parameters for the serial connection in their manual. Good luck. -----Original Message----- From: Stefan Vetter [mailto:[email protected]] Sent: 10 June 2010 19:32 To: [email protected] Subject: [m0n0wall] no reaction after installation Hi I just installed according this installation instructions on an alixboard: http://techunplugged.com/2009/07/22/alix-monowall-firewall-part-1/ When i try to connect nothing happens. My Mac recives no IP-Adress from the embeded monowall. Any ideas? Stefan --------------------------------------------------------------------- To unsubscribe, e-mail: [email protected] For additional commands, e-mail: [email protected]