Re: Traffic shaping using NAT

Lee Sharp <[email protected]> Fri, 16 Jul 2010 11:18:53 -0500

Newsgroups	gmane.comp.security.firewalls.m0n0wall
Message-ID	<[email protected]>

On 07/16/2010 11:07 AM, Steve Yates wrote:

> 	I'm not sure I follow..."ensure that the source isn't NATed"?  We could always give it a public IP but were hoping not to do so.

For the record, NAT breaks a lot of stuff.  That said, we have an 
amazing amount of control in how NAT works on m0n0wall.  What he is 
telling you is that you can configure NAT so that it is turned off for 
the bridged interface.  This can be a bit complex to set up right, which 
is why it is in the "Advanced Outbound NAT" section.

			Lee