Re: Multiple subnets/single interface
John Ackermann N8UR <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Message-ID | <[email protected]> |
I think my problem was a netmask typo -- I *thought* I set /24 but when I looked at the interface config it showed as /32. After setting that properly, I could in fact route from one subnet to the other on the same wire. So, problem solved as far as I can tell. John ---- [email protected] said the following on 07/31/2010 09:00 PM: > > m0n0wall Digest 1 Aug 2010 01:00:00 -0000 Issue 2137 > > Topics (messages 36576 through 36576): > > Multiple subnets/single interface > 36576 by: John Ackermann N8UR > > Administrivia: > > To subscribe to the digest, e-mail: > <[email protected]> > > To unsubscribe from the digest, e-mail: > <[email protected]> > > To post to the list, e-mail: > <[email protected]> > > > ----------------------------------------------------------------------