Re: Was: how to reach modem on WAN port

TNX Jakob. The modem is in bridge mode indeed and PPP assigment works 
but I would like to be able to use the web interface of the modem and 
more important, the modem sends syslog messages which I want to capture 
on miy server on the LAN. I seem to remember that I had this working 
when I tested with OpenWRT, a long time ago. But I want to stick to 
Monowall, though... I'm used to that and it serves me a well for a few 
years already.

EJ


Op 19-1-2011 20:03, Jakob Schwienbacher schreef:
> Hello Egbert,
>
> I'm not an expert. It's just a proposal/question. For which reason do
> you need the IP 192.168.178.254 assigned on the WAN side? As far as i
> know it should be enough to set the monowall's WAN interface to PPPoE.
> The modem (I don't know this type/model) should be configured as modem
> only (bridging) mode. In my opinion this should be enough.
>
> Do you have the possibility to check the PPPoE connection with e.g.
> pppoe on Linux or Windows XP's WAN Miniport tool?
>
> Hth
>
> Regards,
> Jakob
>
> On 19 January 2011 19:31, Egbert Jan van den Bussche
> <[email protected]>  wrote:
>> To continue my thread of Jan, 12:
>>
>> Well, this is with 1.33b1 on silent PC HW with embedded NIC (for WAN) and
>> dual INTEL card for LAN and OPT1.
>>
>> As explaned before I need to reach the modem om say, 192.168.178.1. The WAN
>> connection is PPPoE, what is translated to PPPoA by the modem (yes, this
>> modem is a Vigor120). So the address of WAN is PPP assigned.
>>
>> I tried adding a few lines in the<secondary>  block like this
>> <secondaries>
>>   <secondary>
>>     <if>wan</if>
>>     <ipaddr>192.168.178.254</ipaddr>
>>     <prefix>24</prefix>
>>     <descr>test</descr>
>>   </secondary>
>> </secondaries>
>>
>> I probably need a nat rule too to reach that network but don't know how.
>>
>> But I begin to wonder if WAN can have a secondary address at all.
>> I would expect to see it listed under "status interfaces". It isn't.
>>
>> Any remarks? Manuel? Can I have secondary IP address on WAN at all? Also
>> when WAN is on PPP mode?
>>
>> TIA! Egbert Jan (NL)