Re: PC-serial or not

Op 15-2-2011 23:14, Manuel Kasper schreef:
> On 15.02.2011, at 22:06, Egbert Jan van den Bussche wrote:
>
>> I was happily using 1.33b2 on a PC with VGA monitor but wanted to see the behaviour on serial port too. Unfortunately I am not able to find a baudrate that gives readable output in putty. I tried all baudrates I could imagine. The BIOS only allows for IRQ, not speed. Now I want to go back to the non-serial firmware but the loaded serial firmware does not allow me to do that (it worked the other way...). Would be handy if the two PC versions were interchangeable...
>>
>> How should I proceed?
>
> Simply rename the generic-pc image to generic-pc-serial-... and upload it - it will then be accepted.
>
> - Manuel

Offcause! Thanks Manuel. Less work than re-install.

I even moved the config from the PC to Soekris. Just replaced the 
hardware names in the xml file. It worked!

Thanks

Egbert Jan