Re: Adding static IP to WAN interface in PPPoE mode?
Egbert Jan van den Bussche <[email protected]>
| Newsgroups | gmane.comp.security.firewalls.m0n0wall |
|---|---|
| Organization | Thuis |
| Message-ID | <[email protected]> |
Op 20-3-2011 17:35, Nicholas Humfrey schreef: > Hello, > > I have a Soekris net4801 board that I am running m0n0wall version 1.33 on. I tried m0n0wall years ago but moved away to Voyage Linux due to the lack of IPv6 support. Now that m0no0wall supports IPv6, I am giving it another go and it seems to be working well, thanks! > > I have a ZyXEL P-660R-D1 ADSL modem, configured in bridge mode, that is connected directly to m0n0wall's WAN interface. The WAN interface is configured in PPPoE client mode. > > Is there any way to configure a static IPv4 address on the WAN ethernet port, so that I can connect to the modem's admin interface from my LAN, without having to de-configure the PPPoE client? If not using the web interface, perhaps through manual editing of config.xml? > > > Thanks, > > nick. > > > --------------------------------------------------------------------- > To unsubscribe, e-mail: [email protected] > For additional commands, e-mail: [email protected] > Yes. This is possible but not via the web interface. You need to add a shell command to the .xml file to add an alias interface. Furter more jou need to switch on advanced NAT mode and define two Nat rules. You might need a static route in your modem to tell it the way to your LAN. This had been on the list on 20-1-2011 posted bij Anders Hagman. I'm still using his wonderfull explanation Egbert Jan NL