Re: Traffic Shaping on a Filtered Bridge v1.33

Thanks, Chris, for the response.

Can I bridge two Opt interfaces and get the desired effect, or am I pretty
much relegated to traffic shaping throug LAN <-> WAN?

Regards,

-Jamin




On 4/28/11 7:05 PM, "Chris Buechler" <[email protected]> wrote:

>On Thu, Apr 28, 2011 at 3:28 AM, Jamin Cleveland
><[email protected]> wrote:
>> All,
>>
>> Is this possible with the current build?  I just want to do some very
>>simple traffic shaping with the uplink of my LAN switch plugged into the
>>OPT1 port of my Monowall and the WAN port of my Monowall plugged into my
>>upstream router.
>>
>> With traffic shaping off, traffic passes no problem.  If I apply any
>>shaping rules to the WAN interface and enable the shaper, all
>>connectivity to and from the LAN breaks.
>>
>
>That's a scenario I haven't tried, but pretty sure if_bridge +
>ipfw/dummynet + ipf probably don't play nicely together on FreeBSD
>6.2. I think they should on 8.x, and Manuel and Andrew have been
>working on the build tools for the next m0n0wall release based on 8.x,
>so hopefully it will at that point.
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [email protected]
>For additional commands, e-mail: [email protected]
>