RE: PPTP - multiple NICs & Subnets

I was thinking of making the IPs on NIC1 and NIC2 192.168.100.100 and
192.168.200.100 respectively, and the servers behind each would be
statically assigned IPs 192.168.101-200.  Those servers would use
192.168.x.100 as their gateway.  How would I configure the VPN server?
Should I use something different, like 192.168.10.239, and give it
192.168.10.240/28 as you suggested?



-----Original Message-----
From: Lee Sharp [mailto:[email protected]] 
Sent: Friday, April 13, 2012 11:46 AM
To: [email protected]
Subject: Re: [m0n0wall] PPTP - multiple NICs & Subnets

On 04/13/2012 09:21 AM, Shreve, Josh wrote:
> Hello, I apologize for my ignorance but I have a small question.
>
> I am considering using m0n0wall as a virtual appliance in a VMware
host.
> Ideally I would like for the appliance to have 3 NICs:
>
>
>
> *	NIC1 = WAN (public IP)
> *	NIC2 = LAN1 (192.168.100.0/24)
> *	NIC3 = LAN2 (192.168.200.0/24)
>
>
> Would it be possible to configure a PPTP VPN that I can connect to 
> that would allow me to access both the 192.168.100.x and 192.168.200.x

> networks, and if so how?

Yes.  You need to set firewall rules in all of the networks (nic1 nic2
and pptp) and pick a scope that can be found.  I usually place my pptp
scope at the top of my lan with 192.168.x.239 as my gateway, and
192.168.x.240/28 as my slots.

			Lee

---------------------------------------------------------------------
To unsubscribe, e-mail: [email protected]
For additional commands, e-mail: [email protected]