Re: Hardware memory display (was "Recommended hardware ...")

On Jan 21, 2014, at 10:45 AM, Joey Morin <[email protected]> wrote:
> 
> On Tue, Jan 21, 2014 at 1:37 PM, Michael A. Alderete <[email protected]> wrote:
> Is there a way to tell either or both of these from the m0n0wall web GUI? There's only a percentage gauge on the Status > System screen, and I am left wondering "30% of _what_?".
> 
> You can always go to exec.php and run dmesg.  You may need to do it after a reboot, as dmesg uses a circular buffer and if you've seen a lot of system log events the early boot messages will have been overwritten.  Mine has been up for 75 days and I can still see them.


Thanks, that seems to have given me what I needed to know:

> Copyright (c) 1992-2008 The FreeBSD Project.
> Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
> 	The Regents of the University of California. All rights reserved.
> FreeBSD is a registered trademark of The FreeBSD Foundation.
> FreeBSD 6.4-RELEASE-p11 #0: Thu Nov  1 10:58:22 CET 2012
>     [email protected]:/usr/src/sys/i386/compile/M0N0WALL_EMBEDDED
> Timecounter "i8254" frequency 1193182 Hz quality 0
> CPU: Geode(TM) Integrated Processor by National Semi (266.66-MHz 586-class CPU)
>   Origin = "Geode by NSC"  Id = 0x540  Stepping = 0
>   Features=0x808131<FPU,TSC,MSR,CX8,CMOV,MMX>
> real memory  = 134217728 (128 MB)
> avail memory = 105132032 (100 MB)

Looks like it's a 128 meg board.


> ad0: FAILURE - SETFEATURES SET TRANSFER MODE status=51<READY,DSC,ERROR> error=4<ABORTED>
> ad0: 61MB <SanDisk SDCFB-64 Rdg 1.06> at ata0-master BIOSPIO
> Trying to mount root from ufs:/dev/md0

Looks like it's a 64 meg card. (And I can always pop the case to figure that out, I just have to go to the cabinet in the dusty basement...)

So, I think I'm good to go for now. Thanks!

Cheers!

Michael
-- 
Michael A. Alderete
<[email protected]>                tel: +1 (415) 609-5757
<http://aldoblog.com/>