RE: Re: pinhole timing?

[email protected] Tue, 18 Feb 2014 08:27:03 -0700

Newsgroups	gmane.comp.security.firewalls.m0n0wall
Message-ID	<20140218082703.b04a976395a24cd7d7d0649d0446f1fe.141633db88.mailapi@email11.secureserver.net>

 --------- Original Message ---------
 Subject: RE: Re: [m0n0wall] pinhole timing?
From: "Steve Yates" <[email protected]>
Date: 2/18/14 9:22 am
To: "[email protected]" <[email protected]>

> Also, is there any way to monitor the state table so that I'm notified when it
 > changes for a particular target IP address?

 I don't know about "notified" but see if the Diagnostics: Firewall States page in m0n0wall helps. Click on a source or destination IP to filter.

 Also under System: Advanced Setup there is a "TCP idle timeout" setting under Firewall, but "the default is 2.5 hours."

 Steve,

Thanks! That's very helpful. I was not aware of the "idle timeout" setting.

Michael