Re: Double firewall

Just a short follow up:
I successfully put the UTM in bridge mode. Now it works in a full 
transparent mode. I bridged two of the interfaces on the m0n0wall as 
well, so if now something breaks in between I can bridge the bridge.

Which firewall rules do I need on the bridged interface? I have bridged 
OPT1 of my ALIX board to LAN. Under "Firewall rules" I have configured 
the OPT1 interface to pass all traffic coming from the LAN subnet. Is 
this okay? Or do I have to choose the OPT1 subnet?

Regards

P.S.: As you stated, Lee, the bridge mode on the Sophos circumvents the 
license cap. That might prove that the bridge is now a real Layer 2 device.


Am 24.02.2014 17:06, schrieb Lee Sharp:
> On 02/24/2014 02:19 AM, Joschka Blohm wrote:
>> Got it! :)
>> But it is not feasible for my setup. My WAN uplink is done with PPPoE
>> and it works with just one device. Sadly I do not have static WAN IP's...
>
> Well, that does limit your options... ;)
>
>> Nonetheless thank you for your time. :)
>
> Any time.  Good luck!
>
>              Lee
>
> ---------------------------------------------------------------------
> To unsubscribe, e-mail: [email protected]
> For additional commands, e-mail: [email protected]
>

-- 
Diese E-Mail und eventuelle Anlagen können vertrauliche und/oder 
rechtlich geschÃŒtzte Informationen enthalten. Wenn Sie nicht der 
richtige Adressat sind oder diese E-Mail irrtÃŒmlich erhalten haben, 
informieren Sie bitte sofort den Absender und vernichten Sie diese 
E-Mail. Das unerlaubte Kopieren sowie die unbefugte Weitergabe dieser 
E-Mail sind nicht gestattet.

This e-mail and any attachments may contain confidential and/or 
privileged information. If you are not the intended recipient (or have 
received this e-mail in error) please notify the sender immediately and 
destroy this e-mail. Any unauthorized copying, disclosure or 
distribution of the material in this e-mail is strictly forbidden.