Re: PPTP/IPSEC clients

Lee,

So the ³Server address² is the internal IP the PPTP server daemon uses?
Then clients coming in NAT to an IP in the range allowed, and use the
³Server address² in their local routing table as the next-hop for the
remote network?


I also was wondering about the 'IPSEC‹>Mobile clients‹>My Identifier'
field. How do you use this to set up multiple users? I have the multiple
users specified with individual Pre-share keys on the Pre-share key tab,
but I can only enter one user in the ³My identifier² field. How does one
specify multiple users?

Thanks!

Sam



On 4/11/14, 7:30 AM, "Lee Sharp" <[email protected]> wrote:

>On 04/11/2014 06:44 AM, Sam Kretchmer wrote:
>> Hi all,
>>
>> I was wondering if anyone has run into this, or knows what's going on.
>>
>> I am trying to set up a PPTP VPN server on m0n0wall 1.8.
>>
>> Can I have both IPSEC and PPTP clients at the same time?
>>
>> If I give the PPTP server it's own IP, it will not respond to clients
>>on that IP. I have to use the primary IP for clients to connect to, but
>>the client then shows the connection to the secondary IP once connected.
>>
>> What is the purpose of the IP Address field on the PPTP configuration
>>page?
>>
>> So, at the moment, I have a server with IP 1.1.1.1. I have given the
>>PPTP server page an IP of 1.1.1.2. Clients CAN connect to 1.1.1.1, but
>>clients CAN NOT connect to 1.1.1.2.
>
>This is how it is supposed to work.  The IP address and range are IPs
>for once you are connected.  The System IPs are how you connect.
>
>			Lee
>
>
>---------------------------------------------------------------------
>To unsubscribe, e-mail: [email protected]
>For additional commands, e-mail: [email protected]
>